Battery Protect 12/24V 100A BPR000100400

The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

The Battery Protect is a uni-directional device. It can only deal with current in one direction, so either current to a load, or current from a charger, but not both currents at the same time. In addition to this, current only can only flow from the Battery terminal to the Load terminal. In case of use with a load, the battery connects to the Battery terminal, and in case of use with a charger, the charger connects to the Battery terminal.

BatteryProtect key features

• LED display making setup/programming easy.
• Often used in lithium systems due to low standby current in comparison to a relay.
• Lithium system remotely controllable disconnect switch. Note that this no longer uses its internal voltage measurement for disconnecting, as it is now remotely controlled by the BMS.
• Ideal for vehicles, solar installations, boats and motorhomes.
• Solid state switching for longevity.
• Lower energy consumption than closing a relay.
• Can act as a battery isolator and be switched remotely.
• Use in conjunction with a BMV-700 series battery monitor for audible alarms and monitoring.
• And why not use the VictronConnect app & Bluetooth Smart dongle with your BMV or MPPT solar charge controller making life even easier.

Datasheet